Full ESD Product List

Antistatic Mats & Workstations

Antistatic Rubber Rolls

Wrist and Heel Ground Straps

ESD Testers and Monitors

Ground Cords & Snaps

Antistatic Hand Tools

ESD Tutorials FREE

Policies

Anti-Static Rubber Roll Mat Material - T3 ProElite

ASM-G24-T3	ASM-B24-T3	ASM-G36-T3	ASM-B36-T3

Anti static rubber roll custom mat material T3 ProElite series
Click these images for a larger view

T3 ProElite series anti static rubber roll material is high quality electro-static discharge (ESD) protection for work surfaces. Available in lengths from 1 linear foot, up to 32.8 linear feet per roll. This mat material may be purchased below either off the roll by the linear foot, or in an entire roll. T3 ProElite series anti-static rubber roll material is 3mm (.12 inch) thick, available in colors blue or gray, and widths of either 24 or 36 inches (23.6 or 35.4 inches actual). This rubber roll mat material may be easily cut to create any custom sized anti-static mat desired.

Consists of a 2 layer rubber lamination - with a top (colored) side static dissipative layer and a bottom (black) side conductive layer. Create your own custom size anti-static bench mats for computer technicians or electronic assembly and repair ESD work stations, or use it as an anti-static shelf or tool drawer liner. Compared to cheaper more rigid PVC anti-static mats which like to stay curled, ProElite rubber mats are pliable, lay flat and conform to work surfaces, have a high tolerance of heat from soldering irons, are less slippery, are more absorbent to - and much less prone to damage from - mechanical impact.

Anti-static mats are used to prevent damage to sensitive electronics devices caused by uncontrolled ESD events. A properly grounded anti-static mat on your electronics work bench is an essential ESD protection measure that pays for itself by preventing down time, protecting production material, and improving your product quality.

To ground this anti static mat material, users will need to install at least one (3/8") 10mm clinch snap near one corner on each mat, (or one snap at each 10 linear feet interval on longer continuous mats), and attach one end of an static mat ground cord to the installed snap and the other end of the cord to earth ground. (Available clinch snaps and ground cord not included).

For additional ESD protection, see our anti-static wrist straps for the personal grounding needs of individual operators.

   T3 ProElite Rubber Roll Specifications

• Actual roll dimensions:
  • 600mm x 10m (23.6 inch x 32.8 feet) for ASM-G24-T3 and ASM-B24-T3
  • 900mm x 10m (35.4 inch x 32.8 feet) for ASM-G36-T3 and ASM-B36-T3
  • T3 ProElite series mat thickness: 3mm (0.12 inch)   (for 2mm thickness see our T2 EconoPro anti static rubber rolls)

Prices and Ordering

Mail or FAX Order T3 ProElite Anti-Static Rubber Roll Mat Material

Static-ESD Home Page .